 |
 |
|
 |
 |
|
 |
 |
 |
The Last Run Details worksheets for simulation diagrams display the details of the last simulation for the selected block. Note that if you are working with a BlockSim 6 file, these details are available only when a single simulation was run. If multiple simulations were run, you must re-simulate in the current version in order for these details to be available.
Note: You can customize the order in which the blocks are displayed in the simulation results by right-clicking inside the diagram sheet and choosing Set Block Order on the shortcut menu. You will need to resimulate the diagram for the new block order to be shown in the results.
ENUM: The index number for each event. This is an identifier that indicates the order in which the events occurred.
Time to Event: The time to each event.
Waiting for Opportunity: The time the block was waiting for an opportunity to be repaired, due to crew conflicts (i.e., time spent waiting for a crew while the crew is busy with another task) and task scheduling (i.e., time that elapses before the start of any task that leads to the block being restored, such as time before a scheduled inspection that triggers a corrective task).
Waiting for Crew: The time the block was waiting for a crew, which is the time associated with the logistic delay of the crew.
Waiting for Spare Part: The time the block was waiting for a spare part.
Time Under Repair: The time the block was under repair (i.e., maintenance duration).
Event Type: The type of event. Possible values include:
CM: corrective maintenance
PM: preventive maintenance
I: inspection
NDI: non-downing inspection
OC: on condition task
OFF: block turned off by state change trigger
F: block failure, no maintenance
© 1992-2019. HBM Prenscia Inc. ALL RIGHTS RESERVED.
 |
E-mail Link |